Project 6 – Desktop Fountain
All of the following Fountain designs were designed by 3D printy
The simplest of the four Fountain designs is the Tower design. Water flows to the top cascades down a few layers and returns back to the reservoir. This Fountain design flows in all direction which is why it works best usually in the centre cell.
£7.50
The second of the four Fountain designs is the waterfall design. Depending on what you would like, your pump settings, this Fountain will either Direct water down across its side or out in a flying ribbon.
£7.50
The third of the four Fountain designs is the Plateau design. The plateau design is designed to guide water down series of shallow bowls until it reaches the basin. Counting the initial plateaus there is room for up to 4 elevations for the water to flow through as it zigzags its way down.
£17.50
The fourth and final of the four Fountain designs is the rhythmic fountain design. This Fountain design is based on a shishi E Doshi, Device which is used to scare off wild animals and occasional percussive hit
£10.00
this model is completely customisable, There in total seven slot so if you wanted multiple fountains please do ask. smooth stones will not be included if not asked for. The original design it was made by 3Dprinty, if you want find more information about the design and where you can print one out yourself, click here. If you would like to purchase a Desktop Fountain model contact me by using
bace will be £8.50
Fountain 1-6 will be shown above
Email; archiefusion360@gmail.com
When writing an email, please state where you are from your name and address, also please be specific on what you want to be ordered.